- HOME >
- PRODUCTS >
- HANDTOOLS >
- Screwdrivers >
- “HAZSEL” Ball Grip Tang-Thru No.230HW2
HAND TOOLS
Screwdrivers, Wrenches, Wire Strippers, and so on.
“HAZSEL” Ball Grip Tang-Thru No.230HW2
"HAZSEL" Ball Grip Tang-Thru
Cannot remove the screw...Here is "HAZSEL"!
*Tang-thru type bit-replaceable Ball Grip. Can be tapped with a hammer.
*Make the bit tip-end bite into the screw recess carefully by tapping with a hammer and loosen the screw slowly by applying force with a hand.
*With a hex bolster (width across-flat 10mm) that enables to apply force to large screws or stuck screws.
*Comes with 1pc. of bit for ?2x100mm that is dedicated for screw removal.
PRODUCT SPEC
| Model | Tip | Overall Lengthmm | Outer C/T | Code No. |
|---|---|---|---|---|
230HW2 |
2 | 105 | 10 | 125252 |
Details
HAZSEL Bit (+)2×100?
Item PKG (mm)
160 x 95 x 42
Contents
Ball Grip Tang-Thru Grip/"HAZSEL" Bit +2x100?
MOVIE
CATALOG / LEAFLET
Precautions
*Always wear protective goggles when working with the product.
*Cannot be used with high hardness screws (drilling screws, coarse thread screws, high hardness stainless screw, and so on).
*Double-ended bit cannot be used for hammer tapping.
*Mounting a bit or replace bits should be done without fail.
*Do not overload the product as this may cause damage to screws or injury.
*Be careful of short-circuit and electric shock during the electric work.
*Do not modify or heat the product because of danger.
*Do not use the product if any abnormality such as cracks and chipping is found.
*Refrain from use in cold weather.
*Make sure of the applications, size, and usage that are suitable for the product before use.
*At home, store the product while paying attention to children.
