●Micro-corrugated edge blade. Cuts assuredly in the targeted point without slipping or sliding.

●Cuts difficult-to-cut textiles including carbon fiber, glass fiber, aramid fiber, fiber-reinforced rubber, soft plastic panel, fishing gut, optical fiber sheathing, etc.

●Micro-corrugated edge blade. Cuts assuredly in the targeted point without slipping or sliding.

●Cuts difficult-to-cut textiles including carbon fiber, glass fiber, aramid fiber, fiber-reinforced rubber, soft plastic panel, fishing gut, optical fiber sheathing, etc.

●Assured cutting even with difficult-to-cut textiles.

●Micro-corrugated edge blade.Cuts assuredly in the targeted point without slipping or sliding.

●Performs all steps from gate-cutting start to end. Outputs end signal at the end of cutting. No need to reprogram operation command ladder program.

●Complicated cutting conditions can be easily programmed for each workpiece using the dedicated controller.

●Performs all steps from gate-cutting start to end. Outputs end signal at the end of cutting. No need to reprogram operation command ladder program.

●Complicated cutting conditions can be easily programmed for each workpiece using the dedicated controller.

●Air hydro type. Enables a constant blade speed that produces clean cuts.

●Stationary blade for easy workpiece positioning. Moreover, the nippers are insulated to protect workpieces against thermal deformation.

●Minimizes blade shaking to ensure precision gate cuts.

●Blades are Teflon-coated to facilitate workpiece removal.

●Requires separately sold Hydro Controller.

●Custom-made blade lengths and cylinder capacities available.

●Stationary blade for easy workpiece positioning. Moreover, the nippers are insulated to protect workpieces against thermal deformation.

●Blade opening/closing speed can be changed.

●Ideal for cutting film and small diameter gates

●Blades are Teflon-coated to facilitate workpiece removal.

●Uses a single stationary blade, so workpieces are easily positioned.

●Blade opening/closing speed can be changed.

●Ideal for cutting of small diameter gates including plastic lenses.

●Blade is Teflon coated, allowing easy removal of works.

●N20, N30 and N50 have an air cock for safety.
(Please see the photo at the left)

●CE-compliant safety lever types are available.